7000 Carriage CARRIAGE: Limit switches reporting carriage is both HOME and AWAY All The carriage firmware detected that both the HOME and AWAY optical interrupters are tripped. This is likely caused by some problem with the HOME/AWAY board or cable. In fact, if the HA-BP cable is not connected and its cable detection is disabled (i.e. masked), this error will be reported. First check that the HA-BP cable detect is not masked (use the "mask" command). If it was masked, and removing the mask ("mask off ...") caused a HA-BP cable error, the missing cable is the cause of the problem. If no HA-BP cable error is reported, the HA-BP cable should still be inspected and reseated. If the error persists, and no foreign objects are blocking the switches, the HOME/AWAY board, HA-BP cable and ALE should be replaced one at a time. Check if there are slipsheets, plates, etc stuck around the exposure head. If not, record error message and call Creo service. Disconnected or improperly seated HOME/AWAY cable (HA-BP) Faulty HOME/AWAY board, cable, or ALE Foreign object tripping switches ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:28 2008 PST